Bu öğeden alıntı yapmak, öğeye bağlanmak için bu tanımlayıcıyı kullanınız: http://hdl.handle.net/11452/23017
Başlık: Production and characterisations of thin films deposited by a novel vacuum coating plant (VCP)
Yazarlar: Koçkar, Hakan
Meydan, Turgut
Güngör, Erdal
Uludağ Üniversitesi/Fen-Edebiyat Fakültesi/Fizik Bölümü.
Alper, Mürsel
AAG-8795-2021
7005719283
Anahtar kelimeler: Engineering
Instruments & instrumentation
Vacuum coating
Magnetic anisotropy
Magnetic properties of thin films
Inplane anisotropy
Magnetic-properties
X ray diffraction
Vacuum
Magnetic films
Hysteresis
Deposition
Coating techniques
Production conditions
Hysteresis loops
Thin films
Yayın Tarihi: 2006
Yayıncı: Elsevier
Atıf: Koçkar, H. vd. (2006). ''Production and characterisations of thin films deposited by a novel vacuum coating plant (VCP)''. Sensors and Actuators, A: Physical, 129(1-2), 188-191.
Özet: This paper reports a novel vacuum coating plant (VCP) system to prepare magnetic thin films. The first step of this extensive investigation was to evaporate and characterise simple iron films on various substrate in order to understand the process of deposition. The source material evaporated by a resistively heated furnace, which was position under the substrate within the VCP system, contains powdered iron of 99.0% in purity and 1-450 mu m in diameter. The magnetic and structural analysis of the films was achieved by using a vibrating sample magnetometer (VSM) and X-ray diffractometer (XRD), respectively, in order to see the effect of production conditions on the films. The magnetic findings indicate that the films produced on flexible kapton (TM) are anisotropic in the film plane whereas the films deposited on glass substrate indicate comparatively less-well defined anisotropy. All films showed planar magnetic anisotropy irrespective of type of substrate used. Furthermore, when these films are subjected to a bending stress within the VSM, the chances in their magnetic hysteresis loops occur. These results indicate a possible future for this technique to deposit sensing devices for stress detection. X-ray measurements show that the films have a typical body centred cubic (b.c.c.) alpha-iron crystal structure. The chemical compositions of films were confirmed by an inductively coupled plasma atomic emission spectrometry (ICP-AES).
Açıklama: Bu çalışma, 4-6 Haziran 2004 tarihleri arasında Cardiff[Galler]'de düzenlenen 5. European Magnetic Sensors and Actuators Conference'de bildiri olarak sunulmuştur.
URI: https://doi.org/10.1016/j.sna.2005.11.041
https://www.sciencedirect.com/science/article/pii/S0924424705006916
http://hdl.handle.net/11452/23017
ISSN: 0924-4247
Koleksiyonlarda Görünür:Scopus
Web of Science

Bu öğenin dosyaları:
Bu öğeyle ilişkili dosya bulunmamaktadır.


DSpace'deki bütün öğeler, aksi belirtilmedikçe, tüm hakları saklı tutulmak şartıyla telif hakkı ile korunmaktadır.